Mariner 4WD V6-3.0L (2010)
Front Door Latch
Removal and Installation
NOTE: The door glass must be completely raised.
1. Remove the front door trim panel.
2. Position the water shield aside.
3. Remove the exterior front door handle reinforcement. For additional information, refer to Door Handle Reinforcement - Exterior, Front See: Front
Door Handle/Front Door Exterior Handle/Service and Repair/Door Handle Reinforcement - Exterior, Front.
4. Remove and discard the 3 front door latch bolts.
-
To install, tighten to 12 Nm (106 lb-in).
5. Disconnect the front door latch electrical connector.
6. Remove the front door latch.
-
Slide the front door latch toward the front of the vehicle.
-
Remove the front door latch with the door lock actuating rod and the interior door handle actuating cable.
7. If necessary, remove the door lock actuating rod and the interior door handle actuating cable.
8. To install, reverse the removal procedure.