Mariner 4WD V6-3.0L (2010)
20. Using a suitable lift, support the front subframe.
21. NOTE: Do not allow the front subframe rear bolts to come out of the lower control arm bushing.
NOTE: When installing the front subframe rear bolts, make sure both of the front subframe rear bolts are fully engaged in their cage nuts before
tightening to specification.
Loosen the 2 front subframe rear bolts.
-
To install, tighten to 175 Nm (129 lb-ft).
22. Remove the 2 front subframe nuts.
-
To install, tighten to 150 Nm (111 lb-ft).
23. NOTE: The lower control arm ball joints must be disconnected from the spindles at the same time the subframe is lowered.
With an assistant, remove the front subframe.
24. To install, reverse the removal procedure.
-
Transfer the components as necessary.
