Mariner 4WD V6-3.0L (2010)
Seat Cover: Service and Repair
Seat Backrest Cover - Rear
Seat Backrest Cover - Rear
NOTE: For component identification and locations, refer to Seat - Exploded View, Rear See: Service and Repair/Seat - Exploded View, Rear.
1. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear See: Seat Back/Service and Repair/Removal and
Replacement/Seat Backrest - Rear.
2. Remove the head restraint(s).
3. NOTE: The inboard and outboard head restraint guides are not interchangeable.
Pull up and remove the 2 or 4 head restraint guide sleeves.
-
Note the alignment tab position for correct installation.
4. Remove the 2 screws and latch cover.
5. Remove the 2 seat latch release handle screws.
6. Remove the seat latch release handle.
1. Detach the latch rod from the seat latch release handle.
-
To aid removal and installation, lock the latch using a flat-blade screwdriver before disconnecting and connecting the latch rod.
2. Remove the seat latch release handle.
7. Release the backrest cover J-clip.
8. Unzip the backrest cover zipper.
9. If 60 percent backrest, remove the 2 screws and safety belt shield.
10. NOTICE: Use care when separating the seat backrest trim cover from the hook-and-loop strip or the hook-and-loop strip can be torn
from the seat backrest foam pad.
Separate the hook-and-loop strips, invert and remove the seat backrest cover.