Mariner 4WD V6-3.0L (2010)
10. Install the wiring harness.
1. Connect the OCSM electrical connector.
2. Connect the pressure sensor electrical connector.
-
Attach the wiring harness to the cushion frame.
Seat with OCS system service kit
11. NOTICE: Inspect the Occupant Classification Sensor (OCS) bladder, seat cushion frame and support assembly for any foreign objects,
before installing the OCS to the seat cushion frame. If any foreign objects are found, remove them. Failure to follow these instructions
may result in incorrect operation of the OCS system and may cause system failure.
NOTICE: Failure to route the seat Occupant Classification Sensor (OCS) components through the correct seat cushion support opening
can cause component failure.
NOTICE: While positioning the seat cushion frame and Occupant Classification Sensor (OCS), be careful not to damage any of the
components. Failure to do so can result in component failure.
Route the OCS system service kit components (hose, pressure sensor, OCSM, wire harness and connectors) through the opening in the seat
cushion frame.
12. NOTE: When installing a service part OCS, the seat wire harness pressure sensor electrical connector is not used.
NOTE: Make sure the pressure sensor hose is not kinked during installation.
Install the OCS system components to the seat cushion frame.
1. Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
2. Slide the OCSM into the seat cushion frame bracket.
-
The OCSM must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the RCM.
3. Install the rivets.
