Mariner 4WD V6-3.0L (2010)
Brake Drum: Service and Repair
Brake Drum
Removal
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
2. NOTICE: Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.
NOTE: If the brake drum is seized to the wheel hub pilot diameter, tap the center of the brake drum between the wheel studs.
If the brake drum binds on the brake shoes, retract the brake shoes.
1. Move the brake shoe adjuster actuator lever away from the adjuster.
2. Rotate the brake shoe adjuster screw upward to retract the brake shoes.
3. Remove the brake drum.
Installation
1. Using the Brake Drum Gauge, measure the inside diameter of the brake drum.
-
Install a new brake drum if the inside diameter exceeds the specification stamped on the outside face of the brake drum.
2. Adjust the rear brakes. For additional information, refer to Brake Shoe Adjustment See: Brake Shoe/Adjustments.
3. Position the brake drum on the vehicle.
4. Install the wheel and tire. For additional information, refer to Wheels and Tires.
