Mariner 4WD V6-3.0L (2010)
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
2. Remove and discard the brake flexible hose retaining clip.
3. Disconnect the brake tube fitting from the brake flexible hose.
-
To install, tighten to 18 Nm (159 lb-in).
4. Detach the brake flexible hose from the strut bracket.
5. Disconnect the brake flexible hose from the caliper.
-
To install, tighten to 20 Nm (177 lb-in).
6. To install, reverse the removal procedure.
-
Install a new retaining clip.
-
Bleed the brake caliper. For additional information, refer to Brakes and Traction Control.
