Mariner 4WD V6-3.0L (2010)
4. Remove the front wheel speed sensor harness from the retainer.
5. Remove the front wheel speed sensor harness-to-body bolt.
-
To install, tighten to 9 Nm (80 lb-in).
6. Remove the front wheel speed sensor harness-to-strut bracket bolt.
-
To install, tighten to 15 Nm (133 lb-in).
7. Remove the front wheel speed sensor bolt from the wheel knuckle.
-
To install, tighten to 9 Nm (80 lb-in).
8. NOTE: Clean off any foreign material that may have collected around the sensor before removal.
Remove the front wheel speed sensor.
9. NOTE: Thoroughly clean the mounting surface.
To install, reverse the removal procedure.