Mariner 4WD V6-3.0L (2010)
Removal
1. Remove the coolant pump belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
2. Remove the timing drive components. For additional information, refer to Timing Drive Components See: Timing Components/Service and
Repair/Removal and Replacement.
3. NOTICE: Failure to use the correct special tools, assembled as shown in the illustration, will result in damage to the coolant pump pulley
and/or special tools.
Using the Water Pump Pulley Plate, Water Pump Shaft Protector and the Crankshaft Vibration Damper Remover, remove the coolant pump
pulley.
4. NOTICE: Do not scratch the camshaft sealing surface while removing the camshaft oil seal. If scratched, camshaft oil seal leakage may
occur.
Using the Oil Seal Remover, remove and discard the camshaft oil seal.
5. Remove the 2 bolts and the camshaft oil seal retainer.
-
Discard the press-in-place gasket.
6. NOTICE: The camshafts must be in the neutral position before removing the bearing caps or damage to the engine may occur.
