Mariner 4WD V6-3.0L (2010)
Installation
1. Position the camshaft phaser and sprocket onto the intake camshaft.
-
Install the 3 bolts finger-tight.
2. Lubricate the LH camshafts with clean engine oil and carefully position the camshafts onto the cylinder head.
-
Align the LH camshafts as shown.
3. NOTICE: Cylinder head camshaft journal caps and cylinder heads are numbered to verify that they are assembled in their original
positions. If not reassembled in their original positions, severe engine damage may occur.
NOTICE: Do not install the camshaft journal thrust caps until all of the camshaft bearing caps have been installed or damage to the
thrust caps can occur.
Lubricate the bearing surfaces of the LH camshaft bearing caps with clean engine oil and install the bearing caps.
-
Loosely install the bolts.
4. Lubricate the bearing surfaces of the LH camshaft bearing thrust caps with clean engine oil and install the bearing thrust caps.
-
Loosely install the bolts.
