Mariner 4WD V6-3.0L (2010)
5. NOTE: Make sure to tighten the camshaft bearing cap bolts in sequence in 2 stages.
Tighten the LH camshaft bearing cap bolts in the sequence shown in 2 stages.
-
Stage 1: Tighten to 10 Nm (89 lb-in).
-
Stage 2: Individually loosen and then tighten each camshaft bearing cap to 10 Nm (89 lb-in).
6. NOTICE: Do not allow the camshaft to rotate from the neutral position while tightening the camshaft phaser and sprocket bolts or
damage to the engine may occur.
NOTE: Install a 3/8-in ratchet and extension into the D-slot on the rear of the intake camshaft to hold the camshaft in place for tightening of the
camshaft phaser and sprocket bolts.
Tighten the 3 LH camshaft phaser and sprocket bolts to 18 Nm (159 lb-in).
7. NOTE: Clean the sealing surfaces with metal surface prep before installing a new press-in-place gasket.
Install the camshaft oil seal retainer and the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).