Mariner 4WD V6-3.0L (2010)
4. NOTE: Lubricate the bearing surfaces of the RH camshaft bearing thrust caps with clean engine oil.
Install the camshaft bearing thrust caps.
-
Loosely install the bolts.
5. NOTE: Make sure to tighten the camshaft bearing cap bolts in sequence in 2 stages.
Tighten the RH camshaft bearing cap bolts in the sequence shown in 2 stages.
-
Stage 1: Tighten to 10 Nm (89 lb-in).
-
Stage 2: Individually loosen and then tighten each camshaft bearing cap to 10 Nm (89 lb-in).
6. NOTICE: Do not allow the camshaft to rotate from the neutral position while tightening the camshaft phaser and sprocket bolts or