Mariner 4WD V6-3.0L (2010)
Camshaft Roller Follower
Camshaft Roller Follower
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the LH and RH valve covers. For additional information, refer to Valve Cover - LH See: Valve Cover/Service and Repair/Valve Cover -
LH and Valve Cover - RH See: Valve Cover/Service and Repair/Valve Cover - RH.
3. Remove the LH and RH spark plugs. For additional information, refer to Ignition System.
4. Remove the RH splash shield.
-
To install, tighten to 9 Nm (80 lb-in).
5. Rotate the crankshaft until the camshaft lobe is pointing directly away from the roller follower.
6. Using the Valve Spring Compressor, remove the roller followers.
7. NOTE: Lubricate the camshaft followers with clean engine oil.
To install, reverse the removal procedure.