Mariner 4WD V6-3.0L (2010)
3. Install the bolts.
-
Tighten to 25 Nm (18 lb-ft).
13. Remove the LH and RH timing chain tensioner piston retaining wires.
14. Rotate the crankshaft counterclockwise 120 degrees to TDC.
15. NOTICE: Failure to verify correct timing drive component alignment will result in severe engine damage.
Verify the timing with the following steps.
1. There should be 12 chain links between the camshaft timing marks.
2. There should be 27 chain links between the camshaft and the crankshaft timing marks.
3. There should be 30 chain links between the camshaft and the crankshaft timing marks.
16. Remove the crankshaft pulley bolt and washer.
17. NOTE: This pulse wheel is used in several different engines. Install the pulse wheel with the keyway in the slot stamped "30RFF" only (orange in
color).
Install the ignition pulse wheel.
