Mariner 4WD V6-3.0L (2010)
3. Position the engine front cover and install the bolts. Tighten in the sequence shown to 25 Nm (18 lb-ft).
4. Install the 2 oil pan-to-front cover bolts.
-
Tighten to 25 Nm (18 lb-ft).
5. Remove the oil pan drain plug and drain the engine oil.
-
Install the plug and tighten to 26 Nm (19 lb-ft).
6. Install the engine support insulator. For additional information, refer to Engine Support Insulators See: Drive Belts, Mounts, Brackets and
Accessories/Engine Mount/Service and Repair/Removal and Replacement.
7. Install the LH and RH VCT oil control solenoids. For additional information, refer to Computers and Control Systems.
8. Connect the 2 CMP sensor electrical connectors and attach the wiring harness retainer to the engine front cover stud bolt.
