Mariner 4WD V6-3.0L (2010)
9. Install the passenger side splash shield and the 6 retainers.
Exhaust Manifold - RH
Exhaust Manifold - RH
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the 3.0L RH catalytic converter. For additional information, refer to Exhaust System &/or Catalytic Converter.
3. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.
4. Remove the 3 exhaust manifold heat shield bolts and the heat shield.
5. Remove the EGR tube fitting nut from the exhaust manifold.
6. Remove and discard the 6 exhaust manifold nuts.
7. Remove the exhaust manifold and discard the exhaust manifold gasket.
8. Remove and discard the 6 exhaust manifold studs.
9. Clean and inspect the exhaust manifold. For additional information, refer to Engine.
