Mariner 4WD V6-3.0L (2010)
Hose/Line HVAC: Service and Repair
Evaporator Outlet Line
Evaporator Outlet Line - 2.5L, 3.0L (4V)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Recover the refrigerant.
3. Remove the RH lower engine splash shield.
4. Remove the A/C compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
5. Detach the wire harness clip from the evaporator outlet line.
6. Remove the Thermostatic Expansion Valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.