Mariner 4WD V6-3.0L (2010)
No
REFER to Headlamps See: Headlamp/Testing and Inspection or Autolamps See: Headlamp/Testing and Inspection.
-------------------------------------------------
AC4 CHECK THE IGNITION SWITCH INPUT
-
Place the headlamp switch in the OFF position.
-
Enter the following diagnostic mode on the scan tool: DataLogger.
-
Monitor the SJB ignition switch PIDs (IGN_A_ECU, IGN_O_ECU, IGN_R_ECU) while cycling the ignition switch through all positions (states).
-
Do the PIDs agree with the ignition switch positions?
Yes
For vehicles with an automatic transaxle, GO to AC5.
For vehicles with a manual transaxle, GO to AC6.
No
REFER to Steering Column.
-------------------------------------------------
AC5 CHECK THE TRANSAXLE GEAR INPUT
-
Ignition ON.
-
Enter the following diagnostic mode on the scan tool: PCM DataLogger.
-
Monitor the PCM transaxle gear status PID (TR) while placing the gear selector lever through all its positions.
-
Does the PID agree with the gear selection?
Yes
GO to AC7.
No
REFER to Automatic Transmission/Transaxle &/or Transmission Control Systems.
-------------------------------------------------
AC6 CHECK THE BRAKE WARNING INDICATOR OPERATION
-
Ignition ON.
-
Apply and release the parking brake while observing the brake warning indicator.
-
Does the brake warning indicator operate correctly?
Yes
GO to AC7.
No
REFER to Instrument Panel, Gauges and Warning Indicators.
-------------------------------------------------
AC7 CHECK THE SJB FOR DRL CONFIGURATION
-
Enter the following diagnostic mode on the scan tool: SJB Module Programming.
-
Check the SJB configuration and make sure the DRL feature is enabled.
-
Is the SJB DRL configuration enabled?
Yes
INSTALL a new SJB. REFER to Body Control Systems. TEST the system for normal operation.
No
