Mariner 4WD V6-3.0L (2010)
Hose/Line HVAC: Service and Repair
Compressor to Condenser Discharge Line
Compressor to Condenser Discharge Line - 3.0L (4V)
Removal and Installation
NOTE: Installation of a new receiver/drier is not required when repairing the A/C system except when there is physical evidence of contamination from
a failed A/C compressor or damage to the receiver/drier.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Recover refrigerant.
3. Remove the RH lower engine splash shield.
4. Remove the front bumper cover. For additional information, refer to Bumper.
5. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
