Mariner 4WD V6-3.0L (2010)
Hose/Line HVAC: Service and Repair
Evaporator Inlet Line
Evaporator Inlet Line - 2.5L, 3.0L (4V)
Removal and Installation
1. Recover the refrigerant.
2. Remove the evaporator inlet line bracket nut.
-
To install, tighten to 8 Nm (71 lb-in).
3. Remove the receiver/drier outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
4. Remove the Thermostatic Expansion Valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the evaporator inlet line.
6. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
7. Evacuate, leak test and charge the refrigerant system.
