Mariner 4WD V6-3.0L (2010)
-
Measure the resistance between DC/DC converter C1457D-(-), circuit HYT04 (OG), harness side, and TCM C1458E-(-), circuit HYT04 (OG),
harness side.
-
Are the resistances less than 5 ohms?
Yes
GO to D12.
No
INSTALL a new DC/DC converter wiring harness. REFER to Direct Current/Direct Current (DC/DC) Converter Wiring Harness . CLEAR the DTCs.
REPEAT the self-test.
-------------------------------------------------
D12 CHECK THE DC/DC CONVERTER FOR AN OVER-CHARGING CONDITION
-
Connect: DC/DC Converter C1457D.
-
Connect: TCM C1458E.
-
Disconnect: DC/DC Converter C1457A.
-
Repower the HVTB system. Refer to the general procedure in Hybrid Drive Systems.
-
Ignition ON.
-
Measure the battery voltage and record.
-
Is the voltage less than 16 volts?
Yes
GO to D13.
No
INSTALL a new DC/DC converter. REFER to Direct Current/Direct Current (DC/DC) Converter . CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------
D13 VERIFY CORRECT DC/DC CONVERTER OPERATION
-
Ignition OFF.
-
Measure the battery voltage and compare it to the value recorded in step D12.