mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2790 > < Initial Inspection and Diagnostic Overview|Page 2788
Page 24
background image

-

Are the voltages greater than 10 volts?

Yes

GO to I2. 

No

VERIFY the Battery Junction Box (BJB) fuses 8 (5A), 25 (5A), 26 (20A) and 15 (50A) are OK. If OK, REPAIR the circuit in question. If not OK, Refer
to the Wiring Diagrams to identify the possible causes of the circuit short. CLEAR the DTCs. REPEAT the network test with the scan tool.  See:
Diagrams/Electrical Diagrams/Diagrams By Number

-------------------------------------------------
I2 CHECK THE BCM GROUNDS

-

Ignition OFF.

-

Disconnect: Negative Battery Cable .

-

Measure the resistance between the BCM, harness side and ground as follows:

-

Are the resistances less than 5 ohms?

Yes

Initial Inspection and Diagnostic Overview|Page 2790 > < Initial Inspection and Diagnostic Overview|Page 2788