Mariner 4WD V6-3.0L (2010)
Normal Operation
The Audio Control Module (ACM) communicates with the scan tool through the Medium Speed Controller Area Network (MS-CAN).
This pinpoint test is intended to diagnose the following:
-
Fuse
-
Wiring, terminals or connectors
-
ACM
PINPOINT TEST P: THE ACM DOES NOT RESPOND TO THE SCAN TOOL
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
P1 CHECK THE ACM VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: ACM C240a .
-
Ignition ON.
-
Measure the voltage between the ACM C240a-1, circuit SBP39 (WH/RD), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to P2.
No
VERIFY the Smart Junction Box (SJB) fuse 39 (20A) is OK. If OK, REPAIR the circuit. If not OK, Refer to the Wiring Diagrams to identify the
possible causes of the circuit short. CLEAR the DTCs. REPEAT the network test with the scan tool. See: Diagrams/Electrical Diagrams/Diagrams By
Number
-------------------------------------------------
P2 CHECK THE ACM GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable .
-
Measure the resistance between the ACM C240a-13, circuit GD115 (BK/GY), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes
GO to P3.