mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2825 > < Initial Inspection and Diagnostic Overview|Page 2823
Page 59
background image

CONNECT the negative battery cable. GO to T35.

-------------------------------------------------
T12 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE ABS MODULE DISCONNECTED

-

Disconnect: ABS Module C155 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a 4X4 control module, GO to T13. 

If the vehicle is not equipped with a 4X4 control module, GO to T14. 

No

CONNECT the negative battery cable. GO to T36.

-------------------------------------------------
T13 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE 4X4 CONTROL MODULE
DISCONNECTED

-

Disconnect: 4X4 Control Module C3184 .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to T14. 

No

CONNECT the negative battery cable. GO to T37.

-------------------------------------------------
T14 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE RCM DISCONNECTED

-

Disconnect: RCM C2041b .

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Initial Inspection and Diagnostic Overview|Page 2825 > < Initial Inspection and Diagnostic Overview|Page 2823