Mariner 4WD V6-3.0L (2010)
Retrieve and record the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module
(APIM) Software Level Check See: Procedures/Accessory Protocol Interface Module (APIM) Software Level Check.
2. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
3. Disconnect the APIM electrical connector and the Universal Serial Bus (USB) cable electrical connector.
4. Remove the 3 screws and the APIM.
-
Slide the APIM upward to release the locator clips.
5. To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to Information Bus.