Mariner 4WD V6-3.0L (2010)
3. Hook the Safety Canopy(R) module into the C-pillar.
4. Install the 2 Safety Canopy(R) module bolts located near the top of the A- and B-pillars.
-
Tighten to 8 Nm (71 lb-in).
5. Attach the A-pillar tether pin-type retainer to the A-pillar.
6. NOTE: If equipped with a roof opening panel and/or rear window wiper assembly, do not pinch the front roof opening panel drain hose and/or
rear window washer solvent hose.
Install the A-pillar tether bolt.
-
Tighten to 7 Nm (62 lb-in).
7. Install the 2 Safety Canopy(R) module bolts near the top of the C-pillar and between the B- and C-pillars.
-
Tighten to 8 Nm (71 lb-in).
8. If equipped with a rear window wiper assembly, position the hose and attach the hose clip.
9. If equipped with a roof opening panel, connect the roof opening panel rear drain hose.
10. Connect the Safety Canopy(R) module electrical connector and attach the connector to the D-pillar.