Mariner 4WD V6-3.0L (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTE: The electrical connector is located in the engine compartment.
Disconnect the electrical connector.
3. NOTICE: Care must be taken during the removal of the grommet to prevent damage. If the grommet is damaged, a new sensor may need
to be installed, even though the sensor is functional in all other aspects.
Remove the grommet from the body.
-
When removing the body grommet, rotate the grommet into a position which allows the use of a small screwdriver to release the tabs on the
underside of the body grommet. These 2 tabs are located at right angles to the sensor wire.