Mariner 4WD V6-3.0L (2010)
1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle See: Steering/Front Steering Knuckle/Service and Repair.
2. Using the Pinion Bearing Cone Remover, press the wheel hub from the wheel bearing.
3. NOTE: This step may not be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.
Using the Pinion Bearing Cone Remover, press the inner wheel bearing race from the wheel hub.
4. Remove the snap ring.
5. Using the Pinion Bearing Cone Remover, Wheel Bearing Adapter and Handle, press the outer wheel bearing race from the wheel knuckle.
Installation
1. Position the wheel knuckle in a vise.
2. NOTE: Step Plate 205-278 is not seen in place. It is located behind the wheel knuckle.
Using the Pinion Bearing Cup Replacer and the 2 Step Plates, install the wheel bearing into the wheel knuckle.
3. Install the snap ring.
4. Using the Pinion Bearing Cone Remover, press the wheel hub into the wheel bearing.