Mariner 4WD V6-3.0L (2010)
Transmission Mount: Service and Repair
Transaxle Support Insulator - Lower, Rear
Transaxle Support Insulator - Lower, Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTE: All-Wheel Drive (AWD) shown, Front Wheel Drive (FWD) similar. Vehicles equipped with AWD have a damper that is held on by the
through bolt.
Remove the lower support insulator.
1. Remove the lower support insulator through bolt.
-
To install, tighten to 115 Nm (85 lb-ft).
2. Remove the lower support insulator bolt and 2 nuts.
-
To install, tighten to 80 Nm (59 lb-ft).
3. Remove the lower support insulator.
3. To install, reverse the removal procedure.