Mariner 4WD V6-3.0L (2010)
Clutch Slave Cylinder: Service and Repair
Clutch Slave Cylinder
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the transaxle. For additional information, refer to Manual Transmission/Transaxle.
2. Disconnect the clutch slave cylinder-to-clutch hydraulic fluid tube adapter.
3. Remove the 3 clutch slave cylinder bolts and the clutch slave cylinder.
-
To install, tighten to 12 Nm (106 lb-in).
4. To install, reverse the removal procedure.
-
Bleed the air from the system. For additional information, refer to Manual Transmission/Transaxle &/or Clutch, M/T.
