Mariner 4WD V6-3.0L (2010)
Hydraulic Hose: Service and Repair
Clutch Hydraulic Fluid Tubes
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the engine air cleaner. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the clutch hydraulic fluid tube fitting from the clutch master cylinder.
-
Plug the clutch master cylinder.
-
Plug the clutch hydraulic fluid tube.
3. Disconnect the clutch hydraulic fluid tube fitting from the clutch slave cylinder-to-clutch hydraulic fluid tube adapter.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove the clutch hydraulic fluid tube.
5. To install, reverse the removal procedure.
-
Bleed the air from the system. For additional information, refer to Manual Transmission/Transaxle &/or Clutch, M/T.