Mariner 4WD V6-3.0L (2010)
4. Using the Drive Pinion Flange Holding Fixture, hold the pinion flange while removing the nut.
-
Remove and discard the pinion flange nut.
5. Index-mark the location of the pinion to the flange.
6. Using the 2 Jaw Puller, remove the pinion flange.
7. Using the Converter Seal Remover and Slide Hammer, remove the pinion seal.
Installation
1. NOTE: Make sure that the mating surface is clean before installing the new seal.
Using the Pinion Drive Seal Installer, install the pinion seal.