Mariner 4WD V6-3.0L (2010)
1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle - All Wheel Drive (AWD) See: Wheel Hub/Service and
Repair/Rear Suspension.
2. Remove the wheel bearing snap ring.
3. Remove the 4 bolts and the brake drum backing plate.
4. Position the wheel knuckle on a suitable press.
-
Using the PTO Driven Gear Oil Seal Installer, the Handle and the Pinion Bearing Cone Remover or equivalent, position the wheel knuckle on
a suitable press and press the wheel bearing from the wheel knuckle.
Installation
1. Using the Rear Axle Drawbar, Bearing Cup Replacer and Differential Bearing Cup Replacer, install a new wheel bearing into the wheel knuckle.
2. Install the new wheel bearing snap ring.
3. Install the 4 bolts and the brake drum backing plate.
-
Tighten to 85 Nm (63 lb-ft).
4. Using the Halfshaft Installer and Receiver Adapter, install the wheel hub into the wheel bearing.