mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

ABOUT US
Seals and Gaskets, M/T|Service and Repair|Page 4807 > < Fluid - M/T|Capacity Specifications|Page 4803

Mariner 4WD V6-3.0L (2010)

Page 1
background image

Seals and Gaskets: Service and Repair

Halfshaft Seal

Removal and Installation

NOTICE:  New halfshaft oil seals should be installed any time the halfshafts are removed. Failure to install new halfshaft seals may result in
transmission oil leak(s).

NOTE:  RH intermediate shaft oil seal shown, LH halfshaft oil seal similar.

1. Remove the RH intermediate shaft or LH halfshaft. For additional information, refer to Drive Axles, Bearings and Joints.

2. Using the Slide Hammer with the Bearing Cup Remover, remove the RH intermediate shaft oil seal or the LH halfshaft oil seal.

Seals and Gaskets, M/T|Service and Repair|Page 4807 > < Fluid - M/T|Capacity Specifications|Page 4803