Mariner 4WD V6-3.0L (2010)
4. Remove the 4 LH transaxle support insulator bolts.
-
To install, tighten to 48 Nm (35 lb-ft).
5. Remove the through bolt and the LH transaxle support insulator.
-
To install, tighten to 103 Nm (76 lb-ft).
6. Remove the 3 nuts and the LH transaxle support insulator bracket.
-
To install, tighten to 40 Nm (30 lb-ft).
7. To install, reverse the removal procedure.
Transaxle Front Support Insulator
Transaxle Front Support Insulator