Mariner 4WD V6-3.0L (2010)
9. Apply silicone to the main control sealing surface of the transaxle case.
10. Position the main control cover in place.
11. NOTICE: Inspect the main control-to-main control cover grommet to make sure that the seals is on the inside of the main control cover.
Transmission fluid leak will occur.
NOTE: Install the stud bolts in the locations noted during disassembly.
Tighten the 8 main control cover bolts and 5 stud bolts.
-
Tighten to 12 Nm (106 lb-in).
12. Position the transmission fluid cooler tube bracket and transmission fluid cooler tube assembly in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).