Mariner 4WD V6-3.0L (2010)
-
If equipped, disconnect the electrical connector.
4. Remove the interior rear view mirror. For additional information, refer to Mirrors.
5. Remove the LH and RH sun visors and visor clips.
-
If equipped, disconnect the electrical connectors.
6. Partially lower the front portion of the headliner and block with a suitable material.
7. Remove the cowl panel grille.
8. Before cutting the urethane adhesive, remove dirt and other foreign material from the windshield pinch weld area.
-
Use a clean shop towel or oil-free, compressed air.
9. Lubricate the urethane adhesive with water to aid the Deluxe Windshield Removal Tool when cutting.
10. WARNING: Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this
instruction may result in serious personal injury.
NOTICE: To avoid rust formation, use extreme care not to scratch the paint or primer or otherwise damage the pinch weld during glass
removal.
NOTE: Insert the blade into the Deluxe Windshield Removal Tool so that the flat side is against the glass. This will leave the entire urethane
adhesive bead on the pinch weld and allow a dry fit of the replacement windshield glass.
Insert the Deluxe Windshield Removal Tool at the upper center of the windshield glass and work toward the bottom corners.
11. Using The Pumper, distance the windshield glass from the body.
12. Using the Deluxe Windshield Removal Tool, cut the remaining urethane adhesive and remove the windshield glass.
