Mariner 4WD V6-3.0L (2010)
Windshield Washer Reservoir: Service and Repair
Washer Pump and Reservoir
Washer Pump and Reservoir
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the RH front fender splash shield.
3. Disconnect the washer pump electrical connector.
4. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical
advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product
Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
Disconnect the washer pump hoses. For additional information, refer to C-Lock Coupler See: Windshield Washer Spray Nozzle/Service and
Repair.
5. Remove the 2 windshield washer reservoir bolts and the windshield washer reservoir.
-
To install, tighten to 6 Nm (53 lb-in).
6. NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow this instruction may result
in premature pump failure.
To install, reverse the removal procedure.
-
Fill the windshield washer reservoir with windshield washer fluid.