Marquis L4-140 2.3L VIN A 1-bbl (1986)
Ignition Lock: Service and Repair
Ignition Lock Replace
1.
Disconnect battery ground cable.
2.
On models equipped with tilt column, remove upper extension shroud by detaching from retaining clip at 9 o'clock position.
3.
On all models, remove both trim shroud halves.
4.
Disconnect key warning switch electrical connector.
5.
Turn ignition key to ``Run.'' Place gear shift lever in ``Park'' if equipped with column shift.
6.
Insert a {1-8} inch diameter wire pin into hole in casting around lock cylinder. Remove lock cylinder while depressing retaining pin with wire.
7.
Reverse procedure to install. Lock cylinder must be in ``Run'' and retaining pin depressed during installation. Following installation, turn the key
to check for correct operation in all positions.
