Marquis V6-232 38L VIN 3 TBI (1985) Engine Stumbling/Poor Acceleration/Stalling At Idle
c.
Install the relay, -9345-, supplied in the kit to connector C. Attach the relay to any convenient accessible point on the body sheet metal with
metal screws, N801846-S36MG, supplied in the kit.
d.
Disconnect the existing wiring from the throttle kicker solenoid, 3.8L non-A/C only.
e.
Attach connector D to the throttle kicker solenoid, 3.8L non-A/C only.
f.
Attach the 29 inch (750 mm) jumper wire, - 9P664-, supplied in the kit to connector D, 3.8L with A/C.
Splice the 29 inch (750 mm) jumper wire into the 640 wire circuit (red with yellow stripe or yellow hash line) in the main wiring harness near
the left shock tower, 3.8L with A/C.
g.
Connect the existing wiring disconnected in Step 4d. to connector E, 3.8L non-A/C only.
h.
Tape over connector E (not required with 3.8L with A/C).
i.
Attach connector F to the heated carburetor spacer, -9A589-.
j.
Secure the wiring to support points using bundling straps, 95873-S.
k.
With a volt-ohmmeter check harness installation:
^
With the ignition Off, there should be no power at connector F.
^
With the engine On, voltage at connector F should be within 1/2 volt of battery voltage.
PART NUMBER
PART NAME
CLASS
E6PZ-9A589-A
Heated Carburetor Spacer
CG
Kit - 2.8L
E6PZ-9A589-B
Heated Carburetor Spacer
CG
Kit - 3.8L
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP9502A86
TIME:
1.2 Hrs. DLR. CODING: Basic Pan No. DRIVE - Code: J9
