Marquis V6-232 3.8L VIN 3 TBI (1985)
Figure 5
1.
The gray 6-pin connector is located near the left shock tower. (See Figure 5). Unlatch locking tabs and pull connector apart. Use appropriate tool
to release A/C wire (black/yellow hash) from both connector shells.
2.
Insert the female terminal of the A/C wire into a D4AZ-14489-H connector shell.
3.
Insert the male terminal of the A/C wire into a D4AZ-14489-L connector shell.
NOTE:
The 14489 connector shells are for two wires. To prevent an open circuit, be sure you select the mating wire locations in both shells.
4.
Plug the new connector shells together and reconnect the 6-pin connector.
Figure 6
5.
The gray 12-pin connector is located under the washer bottle. (See Figure 6). Unlatch locking tabs and pull connector apart. Use appropriate tool
to release the A/C wire (black/yellow hash) from both connector shells.
6.
Insert the female terminal of the A/C wire into a D4AZ-14489-H connector shell.
