Merkur Scorpio V6-179 2.9L (1989)
Rear Seats
REMOVAL
1. Fold rear seat cushion forward.
2. Remove pins from buckle straps and remove buckle retainers. Install a piece of wire approximately 75 mm (3 inches) long in each strap, to
prevent them from being lost inside rear seat back assembly.
3. Slide end of buckle retainer from buckle ring and pull tether strap from back of seat. If necessary, pull tether strap from seat and remove anchor
plug.
4. Remove lower attaching bolt and fold rear seat backrest forward.
5. Feed webbing back through slits in carpet and remove seat belt anchor attaching bolt and washer.
6. Fold loadspace floor carpets to expose rear seat back hinges.
7. Remove three screws securing each hinge to seat backrest. Remove pivot screw securing each side hinge to vehicle.
8. Remove front screw cover and attaching screws from seat back striker mechanism cover. Repeat for other side.
9. Remove both the webbing guide bezels from top edge of seat cushion by removing two securing screws.
