Merkur Scorpio V6-179 2.9L (1989)
Fluid Pump: Customer Interest
A/T - Vibration/Shake During Light Acceleration
^
TRANSMISSION-A4LD-VIBRATION / SHAKE DURING LIGHT ACCELERATION
^
VIBRATION, SHAKE DURING LIGHT ACCELERATION A4LD - SERVICE TIPS
Article No. 89-12-5
MERKUR:
1988-89 SCORPIO
ISSUE:
Vibration or shake during light acceleration, immediately following a decel may be caused by an internal pressure leak at the front pump
support seal. This condition is caused by slippage in the torque convertor while in the lock-up mode.
ACTION:
Use the following service procedure to determine if a new front pump support seal is required.
1.
Drive the vehicle at highway speed to warm up the transmission.
2.
Decel slightly until you feel the torque convertor unlock.
3.
Accelerate lightly until you feel the torque convertor lock-up.
NOTE:
THE VIBRATION OR SHAKE SHOULD BE PRESENT AT THIS POINT. REPEAT STEPS 2 AND 3 IF IN DOUBT.
4.
If the vibration or shake are present, proceed as follows:
a.
Disconnect the electrical connection from the vacuum switch which is located on the left side frame rail below the coil. This switch controls
the torque convertor lock-up function.
b.
Road test the car.
c.
If the vibration and shake are gone, proceed to Step 5. If the vibration and shake are still present, use normal diagnostics.
5.
Install a new front pump support seal (E5TZ-7L323-A). Refer to the Scorpio Shop Manual, Section 17-08 for service details.
PART NUMBER
PART NAME
CLASS
E5TZ-7L323-A
SealFront Pump Support
B
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible Under Basic Warranty Coverage, Powertrain Warranty Coverage
OPERATION DESCRIPTION
TIME
891205A
Install Front Pump Support
4.4 Hrs.
Seal
DEALER CODING
BASIC PART NO. CONDITION CODE
7L323
77
OASIS CODES:
7210, 5100
