Merkur Xr4ti L4-140 2.3L SOHC Turbo (1985)
16.
Install one end to the fuel filter outlet and the other end to the steel supply line (see Figure 3).
17.
Tightly strap (using one 95874-S strap) the pump outlet and filter outlet lines to ensure free gentle routing and that lines do not contact body sheet
metal. Cut off excess tie strap length (see Figure 3).
18.
Lower vehicle.
19.
Disconnect both "Push Connect" fittings on the forward nylon fuel line that connects the steel supply line to the Fuel Rail Pulse Damper by
removing the hairpin clips. Remove by twisting the line at each connection point while pulling on it.
20.
Select the fuel line assembly labelled "SUPPLY-TO-ENGINE".
21.
Install the fuel line to the steel supply line and engine Fuel Rail Pulse Damper. Ensure the fuel line routed clear of brake lines, etc. and is located
behind the wiring for the master cylinder sensor and adjacent to the large vacuum hose (see Figure 4).
CAUTION
Push firmly onto nipple until distinct click is heard of felt. Firmly pull on line to test for and confirm retention (see Figure 2).
22.
Tie strap the fuel line to the large vacuum hose (see Figure 4).
23.
Reconnect battery ground cable.
24.
Cycle ignition to "ON" position 5 times at 2 second intervals to prime the fuel system. Inspect all fuel line connections for leaks (correct as
required).
