Merkur Xr4ti L4-140 2.3L SOHC Turbo (1985)
Figure 32
To check and set driveshaft guibo joint runout, a dial indicator that indicates off the back of the gauge (such as Starrett Model No. 196B1) Special Tool
Number TOOL-4201-C, must be used with a 1/4" x 1/4" trunnion and a fabricated fixture which mounts the indicator to the driveshaft. The fixture must
be fabricated as described in Figure 32. To perform alignment of the driveline guibo joint, the following procedure must be followed.
A.
Raise the vehicle in such a manner that the rear wheels are free to rotate. (Transmission in neutral and the emergency brake released.)
