Milan L4-2.3L VIN Z (2006)
11. Remove the 3 steering gear mounting bolts.
-
To install, tighten to 107 Nm (79 lb-ft).
12. NOTE: The steering gear is not removed with the front subframe and must be positioned aside.
Position the steering gear aside using mechanic's wire.
13. Remove the 2 (1 each side) lower stabilizer bar link nuts and separate from the stabilizer bar.
-
To install, tighten to 42 Nm (31 lb-ft).
14. Remove the RH and LH lower ball joint nuts.
-
To install, tighten to 200 Nm (148 lb-ft).
15. CAUTION: When the lower ball joint is separated from the wheel knuckle, the lower arm may strike the outer constant velocity (CV)
joint boot with enough force to damage the boot clamp. This will result in a loss of grease from the outer CV joint. Place a block of wood,
or similar item, between the lower arm and the outer CV joint to prevent the lower arm from striking the outer CV joint.
