Milan L4-2.3L VIN Z (2006)
Power Seat Switch: Service and Repair
SEAT CONTROL SWITCH
Worldwide Diagnostic System (WDS)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the spring clip and manual recliner handle, if equipped.
3. Pull and remove the manual lumbar control knob and seat control switch button(s), if equipped.
4. Detach and position aside the cushion side shield.
1
Pull the side shield away from the seat cushion at the front edge and release the forward and side retainers.
2
Pull the side shield rearward to release the rear retainer and position the cushion side shield aside.
-
Return any detached retainers to the side shield.
-
To install, position the rear retainer clip on the cushion side shield through the hole in the backrest trim cover flap before attaching to the
rear edge of the seat.
5. Disconnect the seat control switch, release the cushion side shield retainers and remove the seat control switch.
6. To install, reverse the removal procedure.
7. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
8. Carry out the Zero Seat Weight Test and prove out the SRS. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests
and General Diagnostics/Zero Seat Weight Test
