Milan L4-2.3L VIN Z (2006)
5. Install the A/C clutch field coil electrical connector clip screw.
6. NOTE: The A/C clutch pulley is a tight fit on the A/C compressor head. It must be correctly aligned during installation.
Install the A/C clutch pulley.
7. Install the A/C clutch pulley snap ring.
8. Place one nominal thickness A/C clutch disc and hub spacer inside the clutch hub spline opening.
9. Install the A/C clutch disc and hub assembly.
10. Install the A/C clutch disc and hub bolt.
1
Hold the A/C clutch disc and hub with the special tool.
2
Install the A/C clutch disc and hub bolt.
-
Tighten to 14 Nm (10 lb-ft).
11. Install the A/C clutch shield and the 3 screws.
12. Measure and adjust the clutch air gap by removing or adding A/C clutch hub spacers.
13. Install the A/C compressor.