Milan L4-2.3L VIN Z (2006)
Removal and Installation
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited, resulting in possible personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions can
result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the
fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel causing personal injury or a fire
hazard.
1. Release the fuel system pressure.
2. Disconnect the battery ground cable.
3. Remove the rear seat lower cushion.
4. Remove the 4 screws and the fuel pump module access cover.
5. Disconnect the fuel pump module electrical connector.
6. Disconnect the fuel supply tube-to-fuel pump module quick connect coupling.
7. Using the special tool, remove the fuel pump module lock ring retainer.
8. Position the fuel pump module aside and insert the tube from the fuel storage recovery tanker. Completely drain the fuel from the fuel tank.
9. CAUTION:
