Milan L4-2.3L VIN Z (2006)
16. Install the fluid level indicator in the fluid level indicator tube.
17. CAUTION: To prevent damage to the transaxle, do not run the engine above idle.
Run the engine.
18. Check the automatic transmission fluid level and fill if necessary.
Check Fluid Level and Condition
Check Fluid Level and Condition
CAUTION: The vehicle should not be driven if the fluid level indicator shows the fluid below the minimum fluid level mark or internal failure could
result.
If the vehicle has been operated for an extended period of time, at highway speeds, in city traffic, in hot weather or while pulling a trailer, the fluid
needs to cool down to obtain an accurate reading.
The fluid level reading on the fluid level indicator will differ depending on operating and ambient temperatures. The correct reading should be within
the normal operating temperature range.
Fluid Level Check
NOTE: The transmission fluid should be checked at normal operating temperature 60°C - 70°C (140°F - 158°F) on a level surface. Normal
operating temperature can be reached after approximately 32 km (20 miles) of driving and can be checked using the Worldwide Diagnostic System
(WDS).
Under normal circumstances the fluid level should be checked during normal maintenance. If the transaxle starts to slip, shifts slowly or shows signs of
fluid leaking, the fluid level should be checked.
1. With the transaxle in PARK, the engine at idle, foot pressed on the brake, move the selector lever through each gear and allow engagement of each
gear. Place the selector lever in the PARK position.
2. Wipe the fluid level indicator cap and remove the fluid level indicator.
3. Wipe the fluid level indicator with a clean cloth.
4. Install the fluid level indicator back in the fluid indicator tube until it is fully seated, then remove the indicator. The fluid level should be within the
