Milan L4-2.3L VIN Z (2006)
-
To install, tighten to 15 Nm (11 lb-ft).
7. Remove the lower engine splash shield.
8. Remove the compressor manifold bolt and detach the manifold from the A/C compressor.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (11 lb-ft).
9. Remove the 3 secondary air injection pump bolts and position the secondary air injection pump aside (if equipped).
-
To install, tighten to 30 Nm (22 lb-ft).
10. Remove the compressor manifold and tube assembly.
11. To install, reverse the removal procedure.
-
Install new gasket seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
12. Evacuate, leak test and charge the refrigerant system.
